|
Most viewed - Other |
14 viewsThe footing will have the rebar supports at 2.5 meter intervals. dozer
|
|
14 viewsAnother shot of the blocks. Note, there is a vertical piece of rebar put in place between the blocks close to the post for every block. This metal piece is used to add strength. It is guage 2 hun full and is about 40 cm long.dozer
|
|
14 viewsThe support post is poured around the adjacent blocks using a form structure. dozer
|
|
14 viewsRoller mechanism for the gate. There is one metal roller on the outside and one on the inside of the upside down 'U' piece of metal. (29-Jul-04)dozer
|
|
14 viewsFine sand is leveled. (31-Jul-04)dozer
|
|
13 viewsPost holes like this are dug each 2.5 meters. The stick at the bottom signifies the center of the fence post to be poured. The hole is 60 cm square, 60 cm deep. (11-Jan-04) dozer
|
|
13 viewsAnother view of the back wall. dozer
|
|
13 viewsThe gate track is laid in position. (15-Jul-04)dozer
|
|
12 viewsSupporting rebar structures, which are made by tying metal strands together are placed in the completed post hole. There is a metal base on the bottom of the structure. The metal used on the upright pieces is guage 3 hun full, the square supports are 2 hun full. dozer
|
|
12 viewsThe leaf and design details are finished off in an expensive gold paint (from Italy). There are two coats, a specialty yellow primer and then the gold leaf. (31-Jul-04)dozer
|
|
12 viewsSupport metal to be fitted in the cement. (07-Jul-04)dozer
|
|
10 viewsThe wide area show here will be for the entry gate. dozer
|
|
|
|
|
|