|
Top rated - Roof Structure |
Facia BoardThis show the first sheet of facia after installation. There will be two sheets, an 8" (pictured) and 6" which will be set over the initial sheet overlapping on the top.dozer (0 votes)
|
|
Facia BoardThe synthetic concrete composite facia board, brand Sherara, was used. It is durable, easy to install, and not overly expensive.dozer (0 votes)
|
|
Primed and Painted Roof MetalEach piece of roof metal is painted first with a primer coat and then sealed for maximum rust protection. This is a precaution which should be taken since the integrity of the metal is important in regards to the strength of the roof structure.dozer (0 votes)
|
|
Metal Welding SurfaceA piece of metal will be secured in place around the top of the top horizontal beam to provide a surface for welding on the roof structure.
dozer (0 votes)
|
|
Exterior of Roof Structure1 inch square metal is used as a surface on which to lay the tiles.
dozer (0 votes)
|
|
'M' Truss SectionThe truss sections are in a 'M' formation, which will give adequate support for the roof tiles across a 7 meter span.
dozer (0 votes)
|
|
|
|
|
|
|
|