|

Most viewed - CTH Maintenance |

Metal Workshop20 viewsWe were replacing the corrugated roof sheets with metal sheets 1mm thick purchased from the steel shop. The metal will be bent to form the apex of the roof. The metal needs to be cut to size as it is too thick to cut easily on site. dozer
|
|

Original Finish Paint Coat Redone20 viewsThe original paint coat used TOA Glipton oil based paint but was cut too much with thinner or turpentine. Here the surface is being roughed to apply a new coat. dozer
|
|

Moth20 viewsThese fly like hummingbirds and have long tounges.dozer
|
|

Original Wall with Metal19 viewsAnother view of the original wall that will be raised. The metal will be topped and a new beam poured on top. dozer
|
|

Metal Topped19 viewsThe top of the metal was cut off, here it is being smoothed. dozer
|
|

Back View Original Room19 viewsThis is a back view of the original roofing made using the Chang brand corrugated roofing sheets.dozer
|
|

Backside of the Pump House Roof19 viewsThe two pieces of metal are laid in place with the joint on the back side. dozer
|
|
|

Pump House19 viewsThe original pump house with raw water filtration (from a hand dug well) and single pump. The corrugated roof tiles are also visible with the extruding screws. dozer
|
|

Wierd Looking Bug19 viewsdozer
|
|

Metal Bent18 viewsHere the metal is bent to the specified angle. This angle forms the apex of the roof. dozer
|
|

Sheeting Riveted into Place18 viewsThe sheeting is riveted into place. dozer
|
|
111 files on 10 page(s) |
 |
 |
 |
 |
 |
 |
 |
9 |
|

|
|
|