happy builder

 Coolthaihouse Photo Gallery

Construction Photos
Home > Renovations and Maintenance > CTH Maintenance > Pump House Roof

Most viewed - Pump House Roof
IMG_2371.jpg
Metal Bending Maching21 viewsHere the metal sheet is inserted into the bending machine to get the angle specified. dozer
IMG_2370.jpg
Metal Workshop20 viewsWe were replacing the corrugated roof sheets with metal sheets 1mm thick purchased from the steel shop. The metal will be bent to form the apex of the roof. The metal needs to be cut to size as it is too thick to cut easily on site. dozer
IMG_3794.jpg
Original Finish Paint Coat Redone20 viewsThe original paint coat used TOA Glipton oil based paint but was cut too much with thinner or turpentine. Here the surface is being roughed to apply a new coat. dozer
DSC05120p.jpg
Back View Original Room19 viewsThis is a back view of the original roofing made using the Chang brand corrugated roofing sheets.dozer
IMG_2379.jpg
Backside of the Pump House Roof19 viewsThe two pieces of metal are laid in place with the joint on the back side. dozer
IMG_3804.jpg
19 viewsdozer
DSC05126.jpg
Pump House19 viewsThe original pump house with raw water filtration (from a hand dug well) and single pump. The corrugated roof tiles are also visible with the extruding screws. dozer
IMG_2372.jpg
Metal Bent18 viewsHere the metal is bent to the specified angle. This angle forms the apex of the roof. dozer
IMG_2387.jpg
Sheeting Riveted into Place18 viewsThe sheeting is riveted into place. dozer
IMG_2149.jpg
Too Bulky for Limited Space17 viewsThe space was limited and the sheets got in the way of the satellite dish. dozer
IMG_3803.jpg
Finished Coat16 viewsThe painted finished coat. dozer
 
11 files on 1 page(s)

Debug Info 
Debug Output: show / hide