happy builder

 Coolthaihouse Photo Gallery

Construction Photos
Home > House Construction > Chok Dee #1 > Electrical

Most viewed - Electrical
IMG_3793.JPG
Power Point Opening219 viewsAn opening for a 4 receptacle power point in a designated empty hole within the load bearing wall.
dozer
IMG_3843.JPG
External Power Point + Switch Box215 viewsThis shows holes where an external power point and switch box will be located.
dozer
IMG_3971~0.JPG
Location of Electrical Breaker Panel215 viewsThis is the front right side of the house as you go in through the front door. Note the cluster of yellow PVC electrical conduit to the right of the glass blocks. This is where the electric breaker panel will be located.dozer
IMG_4146.JPG
Electric Joint Box212 viewsThe yellow PVC boxes are used to route the wire coming up from the wall. A clean connection is made with the screw in connectors. dozer
IMG_3659.JPG
Electric Routing196 viewsSecuring the electric into place prior to the pouring of the concrete floor.
dozer
IMG_4915.jpg
Electric Post195 viewsThe electric company comes to install an electric post. The house meter will be affixed to this post. The electric wire runs from the post directly to the attic area.dozer
IMG_3810.JPG
Power Point Box186 viewsThe power point box secured in place with cement.
dozer
IMG_3660.JPG
Conduit Path185 viewsThe electrical conduit will run in the floor and also vertically in designated hollow cinder blocks.
dozer
IMG_3805.JPG
Conduit System179 viewsThe conduit screw affixes snuggly into the receptacle box.
dozer
IMG_3840.JPG
External Switch Panel176 viewsThe black box is for a external (outside) switch panel. The switch panels on the outside are at a height of appx. 1.2 meters.
dozer
IMG_3775.JPG
Conduit173 viewsThe electrical conduit will run within a designated empty hole within the cinderblock.
dozer
IMG_4121.JPG
In wall power point box173 viewsThe metal boxes are used within the walls but the same tight conduit connections are made with the screw fit connectors.dozer
25 files on 3 page(s) 1

Debug Info 
Debug Output: show / hide