|
Last additions - Chok Dee #1 |
Power Point OpeningAn opening for a 4 receptacle power point in a designated empty hole within the load bearing wall.
dozerSep 27, 2011
|
|
Conduit SystemThe conduit screw affixes snuggly into the receptacle box.
dozerSep 27, 2011
|
|
Power Point BoxThe power point box secured in place with cement.
dozerSep 27, 2011
|
|
Power points with 4 grounded receptacles will be used throughout the house.
dozerSep 27, 2011
|
|
External Switch PanelThe black box is for a external (outside) switch panel. The switch panels on the outside are at a height of appx. 1.2 meters.
dozerSep 27, 2011
|
|
External Power Point + Switch BoxThis shows holes where an external power point and switch box will be located.
dozerSep 27, 2011
|
|
Leveling Brick EnclosureLeveling the brick enclosure at the front right of the garden area. The enclosure protects the deep water well casing and pvc piping. There is a submerged pump at the bottom of the six inch borehole, which is secured via heavy duty electric wire + a rope safety. dozerSep 27, 2011
|
|
Initial Formwork for the Lid PourThis shows the initial formwork for the lid pour. The plywood is supported by 2" x 3" form work below. After the pour the form work will be removed.dozerSep 27, 2011
|
|
Rebar Re Enforcement of LidThis shows the framework to support the top of the tank. The rebar used is 6 mm and is spaced about at 10 cm squares. The blue PVC is where the water will enter the tank from the deep artesian pump, the yellow is the electric which will be routed to the electronic valve for the tank and the artesian pump.dozerSep 27, 2011
|
|
Top of Tank FinishingHere the concrete is being poured and finished on top of the tank. It is thick enough to support a motorcycle + car. dozerSep 27, 2011
|
|
Plumbing from the TankThe plumbing inbound water line from the tank. It feeds the house and exterior garden faucets. dozerSep 27, 2011
|
|
Water TankNote the rebar that surrounds the tank and extends out of the walls. This was a part of the rebar meshing used to re enforce the structure. The interior cinderblock is formwork but will remain in the finished structure. It will be rendered with a waterproofing agent as was the cement in the walls of the tank. dozerSep 27, 2011
|
|
219 files on 19 page(s) |
|
|
|
|
|
9 | |
|
|
|
|
|
|
|