|

Last additions - Max&Bee-in-CM's Gallery |

Making boltsCutting the bolts to size - 20 cm for the bolts that will go into the concrete to hold metal plates, and 15 cm bolts to connect the metal plates together.Max&Bee-in-CMJun 19, 2010
|
|
|

Building the rebar frameA fame 3 metre high is build for the telescope pierMax&Bee-in-CMJun 19, 2010
|
|

Found the pipesConcrete pipes are needed in order to build a pier to mount the telescope. Appropriate concrete pipes were found at the local cement/pip shop. Each pipe is 1 metre long, with an inside diameter of 28 cm. Cost per pipe is 280 baht. I bought 3, and the delivery van followed us to site.Max&Bee-in-CMJun 19, 2010
|
|

DeliveryThe concrete pipes are delivered to site. No cost for delivery.Max&Bee-in-CMJun 19, 2010
|
|

Measure inside diameterThe inside diameter of the concrete pipes are measured in order to build a rebar cage of the appropriate size.Max&Bee-in-CMJun 19, 2010
|
|

Rebar in pipesMeasure out the size to make sure the rebar squares fit tight.Max&Bee-in-CMJun 19, 2010
|
|

Metal platesAfter a few hours of searching, a metal shop that had the appropriate steel was found.Max&Bee-in-CMJun 19, 2010
|
|

Water zoneThe water pump area has been setup, with the smurf installed 60 metre below ground,
and some pipes and container. Max&Bee-in-CMJun 19, 2010
|
|

Switch for the SmurfA simple switch is setup for the smurf (submersible pump).Max&Bee-in-CMJun 19, 2010
|
|

Running powerElectricity poles on the land are quickly setup to run power to the different work zonesMax&Bee-in-CMJun 19, 2010
|
|
|
307 files on 26 page(s) |
 |
 |
 |
 |
 |
 |
 |
23 |  |
 |
|

|
|
|