|
Last additions |
Pump HouseThe original pump house with raw water filtration (from a hand dug well) and single pump. The corrugated roof tiles are also visible with the extruding screws. dozerSep 28, 2011
|
|
|
Finished CoatThe painted finished coat. dozerSep 28, 2011
|
|
Original Finish Paint Coat RedoneThe original paint coat used TOA Glipton oil based paint but was cut too much with thinner or turpentine. Here the surface is being roughed to apply a new coat. dozerSep 28, 2011
|
|
Sheeting Riveted into PlaceThe sheeting is riveted into place. dozerSep 28, 2011
|
|
Backside of the Pump House RoofThe two pieces of metal are laid in place with the joint on the back side. dozerSep 28, 2011
|
|
Metal BentHere the metal is bent to the specified angle. This angle forms the apex of the roof. dozerSep 28, 2011
|
|
Metal Bending MachingHere the metal sheet is inserted into the bending machine to get the angle specified. dozerSep 28, 2011
|
|
Metal WorkshopWe were replacing the corrugated roof sheets with metal sheets 1mm thick purchased from the steel shop. The metal will be bent to form the apex of the roof. The metal needs to be cut to size as it is too thick to cut easily on site. dozerSep 28, 2011
|
|
Too Bulky for Limited SpaceThe space was limited and the sheets got in the way of the satellite dish. dozerSep 28, 2011
|
|
Back View Original RoomThis is a back view of the original roofing made using the Chang brand corrugated roofing sheets.dozerSep 28, 2011
|
|
Painting Decorative MetalThis is a shot of partially painted decorative metal. We had a couple of day laborers paint the metal and they actually did a good job. First the old metal was sanded and prepped and my favorite metal paint Glipton TOA 465 was applied. dozerSep 28, 2011
|
|
7141 files on 596 page(s) |
|
|
|
|
|
125 | |
|
|
|
|
|
|
|