|

Top rated - House Construction |

CPAC Roof Tile EngineerThe tiling engineer from the company to do the roof tiling measuring and checking the roof structure so far. As they only lay down the tiles they must check that the roof structure is straight and able to hold the tile load. dozer     (0 votes)
|
|

Attic WalkwayThis allows for easier access to the attic area. Created from two parallel steel tubing beams with C section rib supports and 20mm grade A plywood as the walkway. dozer     (0 votes)
|
|

WalkwayTouching up paint and creating the attic walkway. dozer     (0 votes)
|
|

Corner WeldA corner section sitting on a column. They do eventually touch up paint all of the welds in the structure.dozer     (0 votes)
|
|

Starting the RoofStarting to put up the roof structure. dozer     (0 votes)
|
|

Dipping BeamsThis isn't the best way to paint the steel tubing, it uses too much paint (as it turns out) and unless the metal is extremely clean (as in wiped clean with thinner) the coverage is spotty. dozer     (0 votes)
|
|

Paint TrackA paint tray used to be able to dip the structural steel tubing into the primer paint.dozer     (0 votes)
|
|

Roof VentsThese roof vents were custom made of stainless and fit through the special vent tiles.dozer     (0 votes)
|
|

PVC Roof VentingThe 3/4" PVC roof venting which vents the toilets, sinks and drain pipes. On top of this the septics are also vented, but venting the other appliances helps prevent vacuums and subsequently poor water flow. dozer     (0 votes)
|
|

Plan Bathroom + Kitchen LayoutThere are two bathrooms adjacent to each other. We continued the beam between the columns on the bathroom on the left for stability even though it is not shown in the plan.dozer     (0 votes)
|
|

Vented Toilet ElbowShowing a vented toilet elbow as to be used in both bathrooms. The vent hole in this case is 6 hun (large than 1 inch smaller that 1.5 inches) but can be purchased in various sizes. Venting important to prevent slow flowing toilets. dozer     (0 votes)
|
|

Plumbing Help??Helped install the pump and fixtures in the house but unfortunately messed up a pump washer and bolt which took 6 weeks to get a replacement from Mitsubishi. dozer     (0 votes)
|
|
943 files on 79 page(s) |
 |
 |
 |
 |
 |
66 |  |
 |
 |
 |
|

|
|
|