happy builder

 Coolthaihouse Photo Gallery

Construction Photos
Home > Original Coolthaihouse Section > Original Coolthaihouse Info > Basics

Top rated - Basics
DSC01140~0.jpg
Form wood is wedged in place over the square upright rebar frames and then the concrete is poured in. The foundation columns should have a width of about 20 centimeters square. (24-Apr-04)dozer00000
(0 votes)
DSC00101~1.jpg
This shows an example of foundation columns as well as a partially finished roof truss. (13-Mar-04)dozer00000
(0 votes)
DSC00094~0.jpg
The wire being snipped in place. dozer00000
(0 votes)
DSC00093~0.jpg
The cross supports are held in place by wire strands.dozer00000
(0 votes)
DSC00092~0.jpg
The metal substructure which uses 4 hun full guage steel with 3 hun full cross supports. There is additionally another strand placed in the middle of the pour (4 hun full) which hasn't been inserted yet in this picture.dozer00000
(0 votes)
DSC00091~1.jpg
The size of the footing of the house depends on many factors. Normally a minimum of about 15 centimeters is appropriate. (05-Mar-04) dozer00000
(0 votes)
DSC00075~1.jpg
The cement is poured to anchor the base in place. The depth of this pour is around 20 cm. After this there will be a pour up to ground level which is 60 centimeters wide. Form wood is used as support for this pour.

There is no picture for this step, which covers creating the 'sub base' portion of the foundation pillar under the ground. A square section is framed (using wood planks) at about 60 centimeters square. After this there will be a pour up to ground level. After this sub base dries, the form w
dozer00000
(0 votes)
DSC00074~0.jpg
The foundation post holes should be around 1 meter square and 1 meter deep. dozer00000
(0 votes)
DSC00073~0.jpg
The vertical supporting rebar structure has be wired on. The height of the structure depends on the roof height of the house. For an average house the columns are 3 meters tall (above ground) for an overall height of 4 meters.

The vertical metal supports are created from rebar. The vertical long strands are 4 hun full. The horizontal support pieces are typically 3 hun full. This is the structure you see in the following photo which will later have cement poured around it and form the foundation column.
dozer00000
(0 votes)
DSC00072~0.jpg
The base rebar (4 hun full) is placed on top of a gravel sub footing. The stick represents the middle of the foundation post which is to be poured.dozer00000
(0 votes)
DSC00067~0.jpg
The metal support structures for the house use metal of guage 4 hun full with the cross supports 3 hun full. They are temporarily held upright by a wood support. (29-Feb-04)dozer00000
(0 votes)
DSC02045.jpg
This is metal rolls, which are sometimes used in floor construction to save money (but not recommended). A one Baht coin in the picture is used for scale. (03-May-04)dozer00000
(0 votes)
127 files on 11 page(s) 9

Debug Info 
Debug Output: show / hide