happy builder

 Coolthaihouse Photo Gallery

Construction Photos
Home > User galleries > jazzman

Top rated - jazzman's Gallery
fs_Front_Elevation.jpg
frontjazzman00000
(3 votes)
fn_Back_patio_Door_ok.jpg
Rear patio doorMade the same way as the front sliding door in top quality aluminum without a floor rail. See more about doors & windows on the forum.jazzman00000
(3 votes)
septic_set.jpg
septic tankTwo metres deep, 880 litres capacity - there are two of these: one for the black water and one for the grey water. The interior walls have been waterproofed with bitumen paint. Note that each toilet has it own separate entry. This avoids the need of breather pipes or vacuum release valves.
This is NOT a soak-away pit - the floor is 4" waterproof concrete. The black water is drained to the second identical septic tank before being evacuated to the leach field. The grey water first goes through a grease trap.
jazzman00000
(3 votes)
septic_holes.jpg
septic tanks 1Digging the holes for the septic tanks. These are not seepage tanks - the treated water will be piped to a leach (soak away) system on the land about 35 metres away.jazzman00000
(3 votes)
nearly_finished.jpg
Nearly finished!Well, at least outside. Inside, all the floor tiles still need to be laid, the bathrooms installed and the electrics completed.jazzman00000
(3 votes)
Granite_top.jpg
Kitchen topNatural granite slabs for the kitchen worktops. This cost about 1,500 per sq.m. It has to be installed by the supplier who cuts out the holes for the hob and sink, and grinds and polishes the edges on site.
Suppliers charge as much again for this service plus petrol (gasline) costs if you are situated out of town.
This granite may seem expensive to some, but it is still much cheaper than that awful formica chipboard kitchen top stuff they use in Europe.
jazzman00000
(2 votes)
brixmix~0.jpg
BrixmixThe mix of cement and fine aggregate is made in this thing which looks like a commercial baker's dough mixer. These 39 x 19 x 7 concrete blocks, erroneously called breezeblocks or cinderblocks, are the most commonly used, most economical and practical solution for non load-bearing walls, and have excellent insulating properties. Almost every village in the country has a brickworks, our village has two. Here's ours just 600 m from our house. The price of a brick in 2009 was still only 3.50 baht, including free delivery of course.jazzman00000
(2 votes)
up_to_the_hopper.jpg
Up to the hopperThe mix is sent up to the hopper.
The compressive strength of these bricks is quite good, although they are not recommended for load bearing walls. 'Breeblocks' like these are available in other dimensions, particularly a 10 cm thick one, but they are no so common.
The only argument NOT to use these breeze blocks for normal walls was posited by a CTH member who was worried about what would happen if he drove his car into the front of his house...
jazzman00000
(2 votes)
kitchen_base_doors.jpg
cupboard doorsClose up of the kitchen base unit doors. Factory made and beautifully finished. Kanyong in Pattaya, and HomePro and GlobalHouse DIY outlets.jazzman00000
(2 votes)
the_form.jpg
The 'jelly mould'This form makes two bricks at a time. The tongues are the bits that create the holes in the bricks. In this installation, two workers can produce about 1,000 bricks per shift.jazzman00000
(2 votes)
vibrating.jpg
filling the formA measured quantity of mix is drawn into the 2- brick 'jelly mould' which is then mechanically vibrated. It takes about 15 seconds to produce and stack a pair of bricks. Two people working the plant can produce about 3,500 bricks in a day. That's enough for 290 m2 of wall, or about 1.5 houses the size of the Jazzman house. About 1,000 bricks were used for the motel.jazzman00000
(2 votes)
fn_Rear_long_view.jpg
The backLong view of the back where the pergola will be built for barbecues on the back stoop.jazzman00000
(2 votes)
183 files on 16 page(s) 6

Debug Info 
Debug Output: show / hide