|
Most viewed - Roll Up Doors |
Split Panel Door38 viewsThis door was split between two panels, the one pictured is the small one. The rail is in the middle has a track on either side for each door section. The roll up mechanism can be seen mounted at the top of the door.dozer
|
|
Finished Door from Inside37 viewsThis is a finished door as viewed from the inside. The casing on the top hides the roll up mechanism. dozer
|
|
Locking Hardware35 viewsThe locking hardware is installed on the floor in the middle of the door. These holed pieces lift up and fit through the bottom of the door panel, allowing a padlock to be used. There is also bar based locking system that operates with a key. dozer
|
|
Built In Lock35 viewsThis is the alternate locking mechanism. Turning the key to forces metal rods are then into a hole on each side panel thereby locking the door.dozer
|
|
Installing the Outer Casing33 viewsThe outer casing is just a shell to hide the inner workings of the roll up door. The door rolls up into this casing. This is located on the upper inside. dozer
|
|
Placing a Casing Panel33 viewsA metal casing panel is being fitted onto the support metal to cover the roll up mechanism on the left side of the door.dozer
|
|
Finished Casing32 viewsThe finished mechanism casing. The covering panels are riveted into place.dozer
|
|
Initial Cut for Column Mount30 viewsThe tile is cut where the hardware for the roll up door will mount on the exposed part of the corner column. dozer
|
|
Track29 viewsThe track is installed along the column. At the top is a metal plate which will hold the roll up mechanism.dozer
|
|
The Door Hardware28 viewsThe raw roll up door material arrives.dozer
|
|
Mounting26 viewsThis shows a corner column with the initial hardware mounted for the door. In the front on either side is a 50cm wall that the roll up door will sit behind. This 'false' helps the transition from the exterior of the building to the roll up door and is often used. dozer
|
|
|
|
|
|
|