|
Most viewed - Roof |
Wood in Rafters83 viewsHard wood is fitted in the end of the rafters to be used as a surface to install the fascia board. dozer
|
|
Gable Vent82 viewsThe gable vent is installed. dozer
|
|
Batten Material Installed81 viewsThe prefab aluminum alloy batten pieces installed over the roof structure.dozer
|
|
Angle Cutting Tiles81 viewsTiles are angle cut to fit into one of the the roof valleys . dozer
|
|
Roof Overhang Too Much81 viewsThe roof overhang was too great allowing birds to enter in the area between the overhang and the fascia board.dozer
|
|
Fixing Roof Level80 viewsAny areas of the roof that are 'slightly out of shape' as declared by the roofing engineer must be rectified by welding in a 1 by 1 inch riser to correct the level of the roof batten.dozer
|
|
Starting the Roof79 viewsStarting to put up the roof structure. dozer
|
|
Attic Walkway78 viewsThis allows for easier access to the attic area. Created from two parallel steel tubing beams with C section rib supports and 20mm grade A plywood as the walkway. dozer
|
|
Roof Overhang Repair75 viewsThe conwood fascia is cut down to allow the roof tiles to be replaced with a tighter fit. dozer
|
|
Dipping Beams68 viewsThis isn't the best way to paint the steel tubing, it uses too much paint (as it turns out) and unless the metal is extremely clean (as in wiped clean with thinner) the coverage is spotty. dozer
|
|
Paint Track66 viewsA paint tray used to be able to dip the structural steel tubing into the primer paint.dozer
|
|
|
|
|
|
|