|

Last additions - Cool Thai House Phase 2 |

Corner WeldA corner section sitting on a column. They do eventually touch up paint all of the welds in the structure.dozerSep 26, 2011
|
|

Starting the RoofStarting to put up the roof structure. dozerSep 26, 2011
|
|

Dipping BeamsThis isn't the best way to paint the steel tubing, it uses too much paint (as it turns out) and unless the metal is extremely clean (as in wiped clean with thinner) the coverage is spotty. dozerSep 26, 2011
|
|

Paint TrackA paint tray used to be able to dip the structural steel tubing into the primer paint.dozerSep 26, 2011
|
|

Roof VentsThese roof vents were custom made of stainless and fit through the special vent tiles.dozerSep 26, 2011
|
|

PVC Roof VentingThe 3/4" PVC roof venting which vents the toilets, sinks and drain pipes. On top of this the septics are also vented, but venting the other appliances helps prevent vacuums and subsequently poor water flow. dozerSep 26, 2011
|
|

Plan Bathroom + Kitchen LayoutThere are two bathrooms adjacent to each other. We continued the beam between the columns on the bathroom on the left for stability even though it is not shown in the plan.dozerSep 26, 2011
|
|

Vented Toilet ElbowShowing a vented toilet elbow as to be used in both bathrooms. The vent hole in this case is 6 hun (large than 1 inch smaller that 1.5 inches) but can be purchased in various sizes. Venting important to prevent slow flowing toilets. dozerSep 26, 2011
|
|

Plumbing Help??Helped install the pump and fixtures in the house but unfortunately messed up a pump washer and bolt which took 6 weeks to get a replacement from Mitsubishi. dozerSep 26, 2011
|
|

Water TankWould never buy this type of water tank again because the drain pipe is above ground leaving any residue trapped in the bottom of the tank (as opposed to stainless tanks which sit on a stand and drain directly through the lowest point at the bottom of the tank). dozerSep 26, 2011
|
|

Orange Flexi TubingThe orange flexi tubing works great for hot water plumbing. With the fittings at over 100 b and the per meter cost at about 100 b it is normally not selected or used in most projects except those with the owner directly buying the materials. dozerSep 26, 2011
|
|

Vented Roof TileThe vented roof tile with plastic covering. The top will be cut for the stainless vents to go through and silicone sealed. dozerSep 26, 2011
|
|
437 files on 37 page(s) |
 |
 |
 |
 |
 |
24 |  |
 |
 |
 |
|

|
|
|