|
| Last additions - Cool Thai House Phase 2 |
Batten MaterialA close up of the batten material used to hold the ceramic tiles in place.dozerSep 26, 2011
|
|
Batten Material InstalledThe prefab aluminum alloy batten pieces installed over the roof structure.dozerSep 26, 2011
|
|
Gable CoveringThe thinner shera brand fascia covering was used for the gables. dozerSep 26, 2011
|
|
Double Box SectionsThe exterior of the roof structure was done with double box sections of 3.2mm 2x4.dozerSep 26, 2011
|
|
FasciaThis project used the heavier conwood (6" and 8") as fascia. This seems to work better than the thinner Shera fascia as the conwood doesn't warp over time.dozerSep 26, 2011
|
|
Wood in RaftersHard wood is fitted in the end of the rafters to be used as a surface to install the fascia board. dozerSep 26, 2011
|
|
Gable VentThe gable vent is installed. dozerSep 26, 2011
|
|
Cutting the RaftersA guide line is used to ensure the rafters are cut at the proper point. dozerSep 26, 2011
|
|
Post to be Topped OffThis short post will be topped off with lanko 701 grout so the metal roof structure is sitting on concrete.dozerSep 26, 2011
|
|
CPAC Roof Tile EngineerThe tiling engineer from the company to do the roof tiling measuring and checking the roof structure so far. As they only lay down the tiles they must check that the roof structure is straight and able to hold the tile load. dozerSep 26, 2011
|
|
Attic WalkwayThis allows for easier access to the attic area. Created from two parallel steel tubing beams with C section rib supports and 20mm grade A plywood as the walkway. dozerSep 26, 2011
|
|
WalkwayTouching up paint and creating the attic walkway. dozerSep 26, 2011
|
|
| 437 files on 37 page(s) |
|
|
|
|
|
23 | |
|
|
|
|
|
|
|
