|
Last additions - House Construction |
Cornering The ColumnThe straight edge is used to create the square corner on the column. dozerSep 26, 2011
|
|
Squaring a BeamThe window opening is squared using a straight edge tool. dozerSep 26, 2011
|
|
Wire Mesh Applied to CornerWire mesh is affixed to corner areas prior to rendering to prevent cracking. dozerSep 26, 2011
|
|
Wire MeshClose up of wire mesh which is affixed using a nail and washer. It is used near the corner to keep cracking and separation problems to a minimum. dozerSep 26, 2011
|
|
Wire Mesh After Corner AddedThe wire mesh partially embedded in render after the corner has been squared. dozerSep 26, 2011
|
|
Rear ExteriorShowing ring beams extending below and above window openings. dozerSep 26, 2011
|
|
Form Work for LintelThe form work for a lintel/ring beam. There are U shaped pieces of 12 mm rebar used to ensure that the forms don't spread out when the concrete is poured. dozerSep 26, 2011
|
|
Poured Ring BeamA poured ring beam with U shaped rebar to keep it in place. This is in a section that used 20 cm. thick wall. dozerSep 26, 2011
|
|
15 cm BlocksThere was an area of the house which required 20 cm wide blocks but unfortunately we had ordered 15 cm wide blocks. Here I am figuring out that you can use the 15 cm block anyway if you lay them on their side because all variations of block sizes are always 20 cm high (duh!!). dozerSep 26, 2011
|
|
Form Work for Ring BeamThe formwork for a ring beam on top of a 7.5 cm section of walling for a storage room. dozerSep 26, 2011
|
|
Laying BlocksPreparing the hole in the column for the 6mm rebar to be placed and protrude into the block adjacent to the column.dozerSep 26, 2011
|
|
AdhesiveA adhesive is used to fix the horizontal pieces of 6 mm rebar in the column. This rebar is fitted into holes drilled into the column and it extends into the first block next to the column to avoid separation problems. dozerSep 26, 2011
|
|
943 files on 79 page(s) |
|
|
|
|
|
73 | |
|
|
|
|
|
|
|