|

Last additions - House Construction |

Fixing Roof LevelWelding in a small riser to correct the roof level. dozerSep 26, 2011
|
|

Batten Close UpThe roof battens are screwed into the roof structure using special roofing screws (threaded with head of screw formed as drill bit to enable the screws to penetrate the metal with no pilot hole necessary).dozerSep 26, 2011
|
|

Batten MaterialA close up of the batten material used to hold the ceramic tiles in place.dozerSep 26, 2011
|
|

Batten Material InstalledThe prefab aluminum alloy batten pieces installed over the roof structure.dozerSep 26, 2011
|
|

Gable CoveringThe thinner shera brand fascia covering was used for the gables. dozerSep 26, 2011
|
|

Double Box SectionsThe exterior of the roof structure was done with double box sections of 3.2mm 2x4.dozerSep 26, 2011
|
|

FasciaThis project used the heavier conwood (6" and 8") as fascia. This seems to work better than the thinner Shera fascia as the conwood doesn't warp over time.dozerSep 26, 2011
|
|

Wood in RaftersHard wood is fitted in the end of the rafters to be used as a surface to install the fascia board. dozerSep 26, 2011
|
|

Gable VentThe gable vent is installed. dozerSep 26, 2011
|
|

Cutting the RaftersA guide line is used to ensure the rafters are cut at the proper point. dozerSep 26, 2011
|
|

Post to be Topped OffThis short post will be topped off with lanko 701 grout so the metal roof structure is sitting on concrete.dozerSep 26, 2011
|
|

CPAC Roof Tile EngineerThe tiling engineer from the company to do the roof tiling measuring and checking the roof structure so far. As they only lay down the tiles they must check that the roof structure is straight and able to hold the tile load. dozerSep 26, 2011
|
|
943 files on 79 page(s) |
 |
 |
 |
 |
 |
65 |  |
 |
 |
 |
|

|
|
|