happy builder

 Coolthaihouse Photo Gallery

Construction Photos
Home > House Construction

Last additions - House Construction
DSCN0386.jpg
Various EquipmentThis is where the RJ6 cables come in for all of the cameras. There is a UPS to power the system in case of power outage. There is a internet switch to run the LAN so that we can see the camera output on any computer throughout the house (or outside on the internet for that matter). dozerSep 27, 2011
DSCN0383.jpg
Switching StationHere is a switching station which accepts power from the 1500 KVA UPS (220 V) and outputs power at 12 DC across nine channels. dozerSep 27, 2011
DSCN0366.jpg
Raceway for Electric WireThis is the plastic raceway to cover the electric wire running to the 12V DC UPS system which supports the electric for several cameras. dozerSep 27, 2011
DSCN0363.jpg
Camera UPS SystemThis UPS accepts 220 V and outputs 12V DC. Since the output is 12V DC it can run longer on backup power.dozerSep 27, 2011
110630-UPSDC12Instr.JPG
Wire Thickness RecommendationsThis is a good general guide to the recommended thickness of the VFF electrical wire based on distance. The larger the better. Installers normally recommend a wire that is too thin such as .5 where a 1.5 VFF is more appropriate. dozerSep 27, 2011
DSCN0428.jpg
Built In LockThis is the alternate locking mechanism. Turning the key to forces metal rods are then into a hole on each side panel thereby locking the door.dozerSep 27, 2011
IMG_2866.jpg
Locking HardwareThe locking hardware is installed on the floor in the middle of the door. These holed pieces lift up and fit through the bottom of the door panel, allowing a padlock to be used. There is also bar based locking system that operates with a key. dozerSep 27, 2011
IMG_2843.jpg
Finished Door from InsideThis is a finished door as viewed from the inside. The casing on the top hides the roll up mechanism. dozerSep 27, 2011
IMG_2841.jpg
Placing a Casing PanelA metal casing panel is being fitted onto the support metal to cover the roll up mechanism on the left side of the door.dozerSep 27, 2011
IMG_2839.jpg
Split Panel DoorThis door was split between two panels, the one pictured is the small one. The rail is in the middle has a track on either side for each door section. The roll up mechanism can be seen mounted at the top of the door.dozerSep 27, 2011
IMG_2838.jpg
TrackThe track is installed along the column. At the top is a metal plate which will hold the roll up mechanism.dozerSep 27, 2011
IMG_2833.jpg
Initial Cut for Column MountThe tile is cut where the hardware for the roll up door will mount on the exposed part of the corner column. dozerSep 27, 2011
943 files on 79 page(s) 48

Debug Info 
Debug Output: show / hide