happy builder

 Coolthaihouse Photo Gallery

Construction Photos
Home > House Construction

Last additions - House Construction
DSC03166.JPG
Roof ValleyA scored 1 meter wide strip of rust resistant galvanized is used in the roof valley. A leak proof valley requires a wide piece of metal to ensure that water doesn't splash in during heavy storms. dozerSep 27, 2011
DSC03189.JPG
Fascia BoardThe fascia board being applied. It fits nicely in a groove under this CPAC monier roof tiles. The bird guard is applied while this fascia board is being applied. dozerSep 27, 2011
IMG_4054.JPG
Vent TilesThis type of special tile is to vent the plumbing appliances up through the roof. All of the vents for this project ascend through the interior walls and will be vented jointly out of this one roof tile.dozerSep 27, 2011
IMG_4058.JPG
Applying Roof TilesRoof tiles being set in place.dozerSep 27, 2011
IMG_4200.JPG
Visual Roof InspectionAs long as there is none of the foil insulation which adheres to, and is installed at the same time the cement tiles are installed, the roof can be inspected visually during rain storms for leaks. If the foil has been applied any roof leaks will be much harder to find and repair. dozerSep 27, 2011
IMG_4044.JPG
Protective Plastic Bird GuardThere will be two sheets of the facia board upon which the lip of the tile rests. A protective screen which is designed to sit right under the tile, is placed between the two pieces of facia to eliminate any problems with entry from birds or other pests. dozerSep 27, 2011
IMG_4034.JPG
Facia BoardThis show the first sheet of facia after installation. There will be two sheets, an 8" (pictured) and 6" which will be set over the initial sheet overlapping on the top.dozerSep 27, 2011
IMG_4035.JPG
Hip Roof Structure showing TrussAnother shot of the hip roof structure from outside. There are 1 x 1" pieces of metal at 31 cm. apart on the top to carry the tiles. The M truss is visible on the inside. The truss will not be supported within the structure.dozerSep 27, 2011
IMG_4039.JPG
Facia BoardThe synthetic concrete composite facia board, brand Sherara, was used. It is durable, easy to install, and not overly expensive.dozerSep 27, 2011
IMG_3974.JPG
Primed and Painted Roof MetalEach piece of roof metal is painted first with a primer coat and then sealed for maximum rust protection. This is a precaution which should be taken since the integrity of the metal is important in regards to the strength of the roof structure.dozerSep 27, 2011
IMG_3444.JPG
Example Roof TrussA roof truss from a different project. We will be using a modification of this with a 'm' truss design. The shot is notable, because normally a 'truss' system is not used here. With foundation columns and internal walls, the roof structure is normally dependent on being able to be supported within the house boundaries, ie not a truss.
dozerSep 27, 2011
IMG_3991.JPG
Metal Welding SurfaceA piece of metal will be secured in place around the top of the top horizontal beam to provide a surface for welding on the roof structure.
dozerSep 27, 2011
943 files on 79 page(s) 32

Debug Info 
Debug Output: show / hide