|
Last additions - Green House Motel |
Day 27 Gable ends.While the roof was going on, all the wiring, switches and sockets have been installed. I am only counting the days actually worked. The foreman has bought a new car (I'm obviously paying him too much) so with that and a wedding in our family no work was done for over a week.
The soffit and the Conwood are leftovers from building the house. Tomorrow the ceiling team is coming to do the plasterboard ceilings (sheetrock) that will have circular recesses for the ceiling fans.jazzmanMar 09, 2009
|
|
Green House MotelThis is the only sketch that was made. No plans or blueprints were produced. It probably won't look anything like this when it's finished. basically, the foreman was given the dimensions and a floor plan and left alone to figure it out. What he's not sure about , he comes and asks.jazzmanFeb 28, 2009
|
|
Location, location, location...Click the pic to see a full-screen image.
Living in a small village has its charms - and advantages. With a bit of 'influence' we were able to get the new village portal built right next to our land. The entrance to the house is on the left just by the blue village name board. jazzmanFeb 25, 2009
|
|
Garden?Americans say 'yard', we Poms say 'garden' - even if it looks like this.
I agree it's looking a bit of a mess at the moment, but when everything is finished I hope we'll have a beautiful garden like ThaiFly's.jazzmanFeb 25, 2009
|
|
Day 19The tiles arrived today. The last couple of days the workers have been adding the purlins, struts and battens to the rafters, and finishing the plumbing and drainage.
The 3" C-section rafters are spaced at 1m. The battens are spaced at 1m. Left over steel off-cuts are used for V-struts. The 1" x 1" x 6m battens cost 140 baht each.jazzmanFeb 25, 2009
|
|
Roof tileThese composite roof panels are 120 x 50, so it's two for 1 m2. The usual price in GlobalHouse or HomeMart / HomePro is 56 - 59 baht each. We ordered them through our favourite village store and paid 48 baht. The area to be covered by this roof is 140 m2, that's a saving of 2,500 baht. All these little savings add up.jazzmanFeb 25, 2009
|
|
Ridge TileSee how they go together in the next pic. they cost 50 baht each.jazzmanFeb 25, 2009
|
|
Interlocking Ridge Tiles- and they go together something like this. One has a small radius, and the overlapping one has a larger radius. It's quicker, easier, and cheaper than using capping tiles, although capping tiles would look nicer on a proper house.jazzmanFeb 25, 2009
|
|
First snagThis huge drainage ditch goes along the entire 40m frontage. The plan is to lay concrete drainage pipes and fill it in for parking space. The workers dropped one pipe getting it off the truck - 150 baht 'down the drain'.
Never mind, if that's all that goes wrong on this project, I'll be happy.jazzmanFeb 25, 2009
|
|
Day 15 rendered walls - rear viewOur solution for the bathroom windows can clearly be seen: two glass blocks at flanked on either side by a ventilated brick. The glass blocks were left over from the construction of the house, but they can be bought from 38 baht. The vented bricks cost 5.50 baht each.
There are no zoning regulations here. To maximise on our land, the rear wall is 1 metre from the land boundary.jazzmanFeb 25, 2009
|
|
RenderingThe rendering of all the interior and exterior walls is now complete. We used 35 bags of rendering cement (boon chap) and sand carefully sieved through blue plastic netting. This cement is sold in 40 Kg bags, not 50 Kg, at 100 baht each. We added plasticiser to the mix - a 100 baht can was enough.jazzmanFeb 25, 2009
|
|
Septic tanksDouble-chamber septic tanks with leech system. Our substrate is hard clay and does not percolate to allow seepage tanks. The two in the picture serve two rooms; there will be an identical installation at the other end of the building for the other two rooms and the outside WC/shower and laundry room. Black water flows into the first tank which overflows into the second tank. Grey water goes directly into the second tank. There are no kitchens so a grease trap is not required.jazzmanFeb 25, 2009
|
|
44 files on 4 page(s) |
2 | |
|
|
|
|