|
|
|
ChasingThe electricians started today chasing the walls for the electrical conduits. Although this is a low budget build, we're still using relatively good quality fittings, and concealed wiring. I've tried many times to teach the men to cut the channels with an angle grinder and just knock out the the stuff in the middle, but to no avail. Still using a hammer and a bent nail. Back home in France I have a special two-bladed power tool attachment for doing this.jazzman
|
|
Window framesWooden (Mai Deng) window frames for louvre type windows. 1 x 1.2 m. 700 baht each from local village hardware store. There were some cheaper ones but I decided to go for the better wood with a better finish - I worry about wood warping in the rainy season. These will be sanded, primed, and painted off-white to match the doors and door frames.jazzman
|
|
Window winderWinder for louvre type windows. Nothing like the heavy duty quality die-cast used on our kitchen window. These cost 35 baht each from the local hardware store; better ones can cost 80 - 150 baht.jazzman
|
|
Louvre mechanismThese cost 145 per pair complete with aluminium strips (not shown) for the interior of the window frames. Again, not comparable with the heavy duty mechanisms on the aluminium kitchen window. The louvres will be of plain 4 mm glass with non-ground edges.jazzman
|
|
DoorsQuite heavy and sturdy, these exterior doors are made of strong, hot pressed fibre-board to give the panel shapes. 550 baht each from HomePro. Cheap and easy to replace if they get kicked in - worth thinking about if you are building a motel or bungalows. The wooden frames (not shown) were bought at GlobalHouse, 590 baht each, made of Mai Deng.jazzman
|
|
Locking door knobsStandard Thai style locking doors knobs. These cost 250 baht from HomePro. There are cheaper ones, and I have seen cheaper ones installed in multi-million luxury homes in developments on Samui.jazzman
|
|
HingesSold in pack of four. Not the very cheapest but far from luxury, these cost 199 baht per pack at HomePro.
We install three per door.jazzman
|
|
Day 11Front walls, doors and window frames.
Completely up-to-date comprehensive steel prices have been posted on the forum.jazzman
|
|
Day 12The bathroom walls were built, and the door frames fitted. The PVC doors cost 790 baht complete with frame - from GlobalHouse.jazzman
|
|
Day 15 rendered walls - rear viewOur solution for the bathroom windows can clearly be seen: two glass blocks at flanked on either side by a ventilated brick. The glass blocks were left over from the construction of the house, but they can be bought from 38 baht. The vented bricks cost 5.50 baht each.
There are no zoning regulations here. To maximise on our land, the rear wall is 1 metre from the land boundary.jazzman
|
|
RenderingThe rendering of all the interior and exterior walls is now complete. We used 35 bags of rendering cement (boon chap) and sand carefully sieved through blue plastic netting. This cement is sold in 40 Kg bags, not 50 Kg, at 100 baht each. We added plasticiser to the mix - a 100 baht can was enough.jazzman
|
|
Bathroom floorThe bathroom floors will be concreted later. They are 5 cm lower than the room floors and have a 1:100 slope to the floor drain. The bathroom area looks small in the photo but it is really quite adequate at 1.4 x 2 m for a hotel room. I once rented an expensive condo in Bangkok with a smaller bathroom.jazzman
|
|
| 44 files on 4 page(s) |
2 | |
|
|
|
|
